Among Autel code scanner, I will introduce one OBDII code scanner, which is MaxiScan MS509 OBD2 Scanner, MaxiScan MS509 is specially designed to work with all OBD II compliant vehicles, including those equipped with the next-generation protocol- Control Areal Network (CAN). It is required by EPA that all 1996 and newer vehicles ( cars and light trucks) sold in the United States must be OBD-II compliant and this includes all domestic, Asian and European vehicles.
A small number of 1994 and 1995 model year gasoline vehicles are OBD-II compliant. To verify if a 1994 or 1995 vehicle is OBD-II compliant, check the Vehicle Emissions Control Information (VECI) label which is located under the hood or by the radiator of most vehicles. If the vehicle is OBD II compliant, the label will designate “OBD II Certified”. Additionally, Government regulations mandate that all OBD II compliant vehicles must have a “common” sixteen-pin Data Link Connector (DLC).
For your vehicle to be OBD-II compliant it must have a 16 pin DLC (Data Link Connector) under the dash and the Vehicle Emissions Control Information label must state that the vehicle is OBD-II compliant.
In the following parts, eobd2.net will show step-by-step use Autel MaxiScan MS509 OBD-ii Scanner.
Step one: please connect the MaxiScan MS509 with your vehicle, Click on the "start" button that appears and follow the onscreen instructions to operate the MS509 OBD2 Scanner.
Step two: locate the "Data Link" connection for your vehicle. Every vehicle made after 1996 in the world has one. And it is typically located underneath the dashboard on the driver's side. If it is not located here, there will be a label explaining where it is located in your vehicle.
Step three: connect Autel MaxiScan MS509 OBD-II scanner to the "Data Link" connection. Remove the cover over the connection if one is present. When you insert the cable, you will notice that the power for the OBD-II is on. It is now ready for use.
Step four: press the "Up" or "Down" button on the MaxiScan MS509 Code Reader to highlight the "Read Codes" option on the main menu and press the "Enter" button to select. Wait a few moments as the OBD-II performs a diagnostic scan. If it detects problems, a five-digit code will appear on the screen along with a message telling you how many codes it detected.
Step five: press the "Up" and "Down" buttons on the Autel MaxiScan MS509 EOBD Scanner to cycle through the available codes. Go back to your computer and type in the error OBD-II codes one at a time in the diagnostic program to determine the meaning and cause of each code. If you are unable to find the code in the list, you can find additional codes by the internet.
Wish these steps are helpful.