Update, how-to-use, how-to-adjust mileage with Digimaster 3
Many people have questions or confusion on how to update, how to use, how to adjust mileage with Digimaster 3. The following are update instructions, how to use steps and adjustment directions.
DigiMaster3 update instructions
1. power up digimaster3, and access to internet via LAN interface
2. start main unit, select management—update—software upgrade (start upgrading )
3. showing upgrade ok
How to use digimaster3?
1. Check on types index and there is four areas for vehicle list, respectively Europe, America, Japan & Korea and other. The rule is that you select the area your cars are from. For example, your car is from Europe, you need to choose Europe.
2. See three columns: type (car type digimaster III can do), information (car you select such as selection of Alfa, you could see the detailed Alfa model it covers) and adapter (different vehicles use different one, please don’t do all cars by using the obd cable).
3. Select proper adapter card according to Adapter Selection on digimaster suit case; if you want to do other cars, select Back to index.
4. Vehicles can do with OBD cable is on Europe Area, VW, Passat B5, Golf4, Bora and Beetle.
How to adjust mileage? (Take Toyota Camry for example)
1. select vehicle list: Toyota and got to know Camry need OBP Adapter, select Meter System in display screen
2. select Japan & Korea—toyota—Camry—C46
(There shows you chip types, you should remove the car instrument and find matched chip model.)
3. Remove dip 93c46 (be careful not separate chip angle and make sure not short circuit)
4. plug the chip in the right position and connect the OBP adapter
5. click Next—read out current mileage value—select Yes to correct the mileage
6. input the mileage value you want, enter and click ok
7. recheck the current mileage by clicking on Read mileage to make sure it is the same value you have input and confirm
Hope this information about digimaster3 update, use instruction and mileage correction steps are helpful for you!